CNC Spindle Motors

Three spindle families from one factory: automatic tool change series from 2.2kW to 11kW in ISO20, BT30, ISO30 and BT40, plus air-cooled and water-cooled series from 800W to 5.5kW. Every enquiry is quoted against the machine the spindle will actually run on, not against a catalogue number.

ATC Spindle Motors

ISO20 / BT30 / ISO30 / BT40 · 2.2kW to 11kW

Automatic tool change for production machines that cannot afford to stop for a manual tool swap. Five models in stock range, from a 2.2kW ISO20 for small parts up to an 11kW BT40.

View the ATC series

Air-Cooled Spindle Motors

800W to 5.5kW · fan on the shaft

No chiller, no pump, no coolant to top up. The usual choice for woodworking routers and signage machines in workshops that have no water circuit.

View the air-cooled series

Water-Cooled Spindle Motors

800W to 5.5kW · closed coolant loop

Constant torque and low noise under continuous load, for metal and stone work where an air-cooled motor would run out of thermal headroom.

View the water-cooled series

Which series fits which machine

SeriesTool changePower rangeWhat we stock on this siteTypical machine
ATC Automatic 2.2kW - 11kW ISO20 2.2kW, BT30 5.5kW, BT30 7.5kW, ISO30 9kW, BT40 11kW Production routing and milling where tool changes happen every few minutes
Air-cooled Manual 800W - 5.5kW Air-cooled kit 800W-5.5kW Woodworking routers, signage, nested furniture - no water circuit on site
Water-cooled Manual 800W - 5.5kW Water-cooled kit 800W-5.5kW Metal and stone work with long continuous cuts, or noise-sensitive shops

What actually decides the series

Duty cycle, not power rating. A 5.5kW air-cooled motor and a 5.5kW water-cooled motor cut the same material for the first ten minutes; the difference appears in the eleventh, when the fan-cooled unit has nowhere left to put the heat. If your cuts run without a break, the coolant loop is what buys you the hours. If they are short and interrupted, the air-cooled unit saves you a pump, hoses and the coolant changes.

The second factor is the tool interface. ATC makes sense when the job needs several tools per part; if every job on the machine uses one cutter, automatic tool change adds cost and a compressed-air requirement for nothing.

Spindle kits

Where the motor has to arrive ready to mount, we supply the matched set instead of a bare spindle: motor, drive and mounting hardware specified together, so nothing has to be assembled around a mismatch.

What we confirm before quoting

Send your requirement OEM / wholesale enquiry